Tagged: Klipper

Install Klipper on Sidewinder X1

Install Klipper on Sidewinder X1

The Sidewinder X1 is a capable printer but it’s held back by it’s 8-Bit board. If you Install Klipper on Sidewinder X1, you will be able to print a bit faster. Besides faster printing, it’s much easier to change firmware settings from a single config file. Without further...

High Speed Printing with Fiberlogy PETG

High-Speed Printing with Fiberlogy Easy-PETG

I like to test any printing material I can get my hands on. And I managed to get my hands on some blue Easy-PETG from Fiberlogy. Aroud the same time, I bought yet another printer (the Creality Ender 3) in order to test Klipper with it. So this...

Install Klipper on Ender 3

Install Klipper on Ender 3 with BLTouch support

The Ender 3 is a really good 3D printer for the money. But if you install Klipper on Ender 3 print speed can also be improved while keeping quality. In the following guide i will show you how to install Klipper on Ender 3. I had great results...

Install Klipper on SKR 1.3

Install Klipper on SKR 1.3 – Speed up your prints

The 3D Printing world is currently dominated by Marlin firmware which is installed on most low-buget printers. It’s a great firmware, with good support for a wide range of boards and configurations and i currently use it on some of my printers. Klipper is an alternative 3D Printer...