Category: Printer Profiles

BIQU B1 IdeaMaker Profiles (1)

BIQU B1 IdeaMaker Profiles – PLA / PETG

I previously reviewed the BIQU B1 (BIQU B1 Review: Ender 3 V2 Killer?) and during the process I also tuned the BIQU B1 IdeaMaker profile for it. In this article, I will share my IdeaMaker profile for BIQU B1 made for PLA and PETG. These profiles are tuned...

IdeaMaker Profile for Sapphire Plus

IdeaMaker Profile for Sapphire Plus – PLA / PETG / TPU

IdeaMaker is a slicer made by Raise3D which is a great alternative for the popular Simplify3DIn this article, I will share my IdeaMaker profile for Sapphire Plus made for PLA, PETG and TPU.These profiles are tuned to deliver a good balance between speed and print quality, and worked...

IdeaMaker profile for Sidewinder X1 and Genius

IdeaMaker Profile for Sidewinder X1 and Genius

IdeaMaker is a slicer made by Raise3D which is a great alternative for the popular Simplify3DIn this article, I will share my IdeaMaker profile for Sidewinder X1 and Genius. These profiles are tuned to deliver a good balance between speed and print quality, and worked really well for...

Artillery Genius Profile for Simplify3D and Prusa Slicer

Artillery Genius Profile for Simplify3D and Prusa Slicer

I previously reviewed the Artillery Genius which is an awesome printer. The stock profile is decent, but can be improved. After a few prints, i managed to dial in the profile and get really good results with it. Here is my tweaked Artillery Genius profile for Simplify 3D...

Sidewinder X1 profile for Simplify 3D e1581691908895

Sidewinder X1 profile for Simplify 3D

After the Artillery Sidewinder X1 calibration guide i did a few weeks ago, a lot of people asked me for the slicer profile. So here is the Sidewinder X1 profile for Simplify 3D Sidewinder X1 profile for Simplify 3D After testing various slicers and settings, i found out...

CR-10S PRO Simplify 3D Profile for PETG

CR-10S PRO Simplify 3D Profile for PETG

I tuned my Simplify 3D profile for PETG, on the Creality CR-10S PRO. The results can be seen below. Settings: Layer Height – 0.15 mm Temp: 220C Speed: 60mm/s Retraction: 3mm at 50mm/s Coasting: 1mm CR-10S PRO Simplify 3D Profile for PETG You can download the profile by...

CR10S-PRO Prusa Slicer profile

CR10S-PRO Prusa Slicer profile

After a few failed updates from Cura and general instability, i made the move to Prusa Slicer 2.1. I tweaked the profile with a few test prints, and i find the results better than Cura. CR10S-PRO Prusa Slicer profile Feel free to download the profile from here. It...

This website uses cookies to ensure you get the best experience. Learn More
Accept