Tagged: BLTOUCH

Sidewinder X1 Waggster Mod BLTouch with improved Fan Duct

Sidewinder X1 Waggster Mod BLTouch improved Fan Duct

The Sidewinder X1 has a basic fan duct that works well, but the cooling is done only from one side. I wanted to improve this and because i am using a BLTouch with the Waggster Mod, there were limited options i could choose. So, the improved Fan Duct...

Install Klipper on Ender 3

Install Klipper on Ender 3 with BLTouch support

The Ender 3 is a really good 3D printer for the money. But if you install Klipper on Ender 3 print speed can also be improved while keeping quality. In the following guide i will show you how to install Klipper on Ender 3. I had great results...

How to add BLTouch and 3D Touch to the CR10s PRO

How to add 3D Touch (BLTouch clone) to the CR-10S PRO

The Creality CR-10S PRO is a great printer but unfortunately, the capacitive sensor it ships with is not reliable and i decided to use a 3D Touch instead. This is a BLTouch clone from Aliexpress that does the same thing as the original.If you have concerns regarding the...

SKR 1.3 with TMC2208 drivers in UART mode

Marlin 2.0.x on SKR 1.3 with TMC2208 in UART mode

My old Anet A8 original motherboard had a faulty stepper driver. Without it the extruder was not working properly anymore, so this was a great opportunity to upgrade to a 32 bit motherboard. Being a cheap and powerful board, the SKR 1.3 was the obvious choice. Besides the...