Uncategorized

January 25, 2022

40

How to Install Klipper on Anycubic Vyper: Config and Setup

In this guide I will show you how to Install Klipper on Anycubic Vyper using Mainsail OS. I am in the process of installing Klipper…

September 17, 2021

12

I must warn you right from the start, that this article might look like a rant, and it probably is. But I need to address…

August 6, 2019

2

I like to test any printing material I can get my hands on. And I managed to get my hands on some blue Easy-PETG from…

June 23, 2019

2

Did you know that you can have a 3D representation of your printer inside the slicing software? The default build plate from Simplify 3D is…

May 21, 2019

My old Anet A8 original motherboard had a faulty stepper driver. Without it the extruder was not working properly anymore, so this was a great…