Tagged: SKR 1.3

Duet Firmware for SKR Boards

Duet Firmware for SKR Boards – RRF on SKR 1.3 / 1.4

People interested in 3D printing probably heard about the SKR boards from BIGTREETECH. Now, you can install the Duet firmware for SKR boards and run the RepRap Firmware on SKR 1.3 / SKR 1.4. To be more specific, you can install it on any board that uses the...

Ender 3 V2 vs Artillery Genius Which one to buy

Ender 3 V2 vs Artillery Genius – Which One To Buy?

Creality just announced the Ender 3 V2. An upgraded version of the extremely popular Ender 3 which at the moment is a best buy for a beginner. The Ender 3 V2 is available for preorder on Creality’s site for 279$ or Banggood for 259$. Today, I will do...

SKR 1.3 upgrade for Sidewinder X1

SKR 1.3 Upgrade for Sidewinder X1

The SKR 1.3 upgrade for the Sidewinder X1 is a big improvement over the stock configuration. It updates the printers’ capabilities to 32 bit, makes it a bit quieter and allows for easier firmware upgrades. I previously reviewed the Sidewinder X1 and it’s a good machine in its...

Install Klipper on SKR 1.3

Install Klipper on SKR 1.3 – Speed up your prints

The 3D Printing world is currently dominated by Marlin firmware which is installed on most low-buget printers. It’s a great firmware, with good support for a wide range of boards and configurations and i currently use it on some of my printers. Klipper is an alternative 3D Printer...

SKR 1.3 with TMC2208 drivers in UART mode

Marlin 2.0.x on SKR 1.3 with TMC2208 in UART mode

My old Anet A8 original motherboard had a faulty stepper driver. Without it the extruder was not working properly anymore, so this was a great opportunity to upgrade to a 32 bit motherboard. Being a cheap and powerful board, the SKR 1.3 was the obvious choice. Besides the...