Tagged: AM8

Custom Build Plate Collection for 3D Printers

Custom Build Plate Collection for Prusa Slicer

I started using Prusa Slicer a lot more in the past few weeks with great results so i thought i make it look better. For each of my printers i added a custom build plate. This improves looks and it also makes it easier to see what printer...

High Speed Printing with Fiberlogy PETG

High-Speed Printing with Fiberlogy Easy-PETG

I like to test any printing material i can get my hands on. And i managed to get my hands on some blue Easy-PETG from Fiberlogy. Aroud the same time, i bought yet another printer (the Creality Ender 3) in order to test Klipper with it. So this...

Install Klipper on SKR 1.3

Install Klipper on SKR 1.3 – Speed up your prints

The 3D Printing world is currently dominated by Marlin firmware which is installed on most low-buget printers. It’s a great firmware, with good support for a wide range of boards and configurations and i currently use it on some of my printers. Klipper is an alternative 3D Printer...

SKR 1.3 with TMC2208 drivers in UART mode

Marlin 2.0.x on SKR 1.3 with TMC2208 in UART mode

My old Anet A8 original motherboard had a faulty stepper driver. Without it the extruder was not working properly anymore, so this was a great opportunity to upgrade to a 32 bit motherboard. Being a cheap and powerful board, the SKR 1.3 was the obvious choice. Besides the...